Specifications1
Throat Diameter
36 mm. (1.4 in.)
8 Ω
Nominal Impedance
Minimum Impedance
Power Handling
7.6 Ω
(1200 –20000 Hz)
2
Nominal
80 W
160 W
108 dB
3
4
Continuous Program
Sensitivity (1W/1m)
Frequency Range
1 – 18 kHz
1.2 kHz
65 mm. (2.5 in.)
Aluminium
0.15 mH
5
Recommended Crossover
Voice Coil Diameter
Winding Material
Inductance
Diaphragm Material
Flux Density
Also available in 16 Ω, data upon request
Titanium
1.75 T
Mounting and Shipping Informations
Two M6 holes 180° on 76 mm. (3 in.) diameter
Three M6 holes 120° on 57 mm. (2.2 in.) diameter
Overall Diameter
Depth
Net Weight (1 unit)
Shipping Weight (2 units)
Shipping Box (2 units)
156 mm. (6.1 in.)
65 mm. (2.5 in.)
4.3 Kg. (6.4 lb.)
9.2 Kg. (20.2 lb.)
210x210x190 mm.
(8.3x8.3x7.5 in.)
1
Driver mounted on B&C ME 90 horn.
2
2 hours test made with continuous pink noise signal (6 dB crest factor) within
the specified range . Power calculated on rated minimum impedance.
DE 600 | Hf Compression drivers
3
Power on Continuous Program is defined as 3 dB greater than the Nominal
rating.
1.4” high frequency compression driver, titanium diaphragm,
2.5” flat aluminium wire voice coil, low distortion, extremely
good response from 1.2 kHz. to 18 kHz.
4
Applied RMS Voltage is set to 2.83V for 8 ohms and 4V for 16 ohms Nominal
Impedance. Average SPL from 1000 to 18000 Hz.
5
12 dB/oct. or higher slope high-pass filter.
1
|